Modifikácií
tovar | |
|---|---|
Acetone Liquid 434-1L | |
Acetone Liquid 434-4L |
tovar | Artikel | Náklady | Objednať | |
|---|---|---|---|---|
Acetone Liquid 434-1L | €0 | |||
Acetone Liquid 434-4L | €0 |
The 434 Acetone is a super-fast drying, VOC-exempt, and zero residue solvent.
It is very useful for 3D printing because it can be used to improve adherence of the ABS plastic to the printing bed. The acetone vapors can also be used to smooth the surface of finished 3D printed pieces.
It can be used as a diluent to meet VOC regulations or to clean hard to clean organic residues. The fast drying time of the 434 makes this a good choice for spray application that require low VOC and quicker drying times.
Features & Benefits
- Enhances Adhesion to the Print Bed for 3D Printing
- Smooth Finishing of 3D Printed Pieces
- Highly Miscible with Other Common Organic Solvents
- Fast Evaporation Rate
- VOC Exempt
Contact MG Chemicals if custom packaging or sizes are required
Make necessary adjustments according to your paint and spray gun equipment usage instructions. A 1.0 (paint):1.0 (thinner) dilution is a common starting point. If sagging is observed, reduce the thinner ratio.
ATTENTION!
It is preferable to use this thinner system in a temperature controlled environment. Avoid high temperatures or humidity, which can lead to dry spray and blushing respectively.
| Physical Properties | Method | Value |
|---|---|---|
| Color
Odor Other Threshold | - | Clear
Ketone, nail polish remover 62 ppm |
| Density at 25°C [77 °F]
Viscosity at 25°C [77 °F] Flash Point | Brookfield SP1
Closed Cup | 0.79 g/mL
0.5 cP [0.0005 Pa•s] -17 °C [1.4 °F] |
| Freezing Point
Boiling Point Vapor Pressure at 25°C [77 °F] | Tag closed cup | -94 °C [-70 °F]
56 °C [133 °F] 24.3 kPa [182 mm of Hg] |
| Relative Evap. Rate (BuAc = 1)
Volatile Organic Content (VOC) MIR value | 6.3
VOC-Exempt 0.43 g O³/ g of product | |
| Solvation Parameters | Values | |
| Solubility in water | Highly soluble | |
|
Hansen Solubility Parameters *
|
(cal/cm³)½
| [MPa]½\
15.6 10.3 6.8 |
| Total | 9.8 | 20.1 |
Compatibility
Substrate Compatibility: Active on plastics. Its etching action can remove the need for surface preparation steps for plastics. The high solvent power can also cut through residual contaminants.
ATTENTION! Use with care on thin plastics or parts that are chemically sensitive. If this diluents is too active, dilute or substitute it with a diluents with less solvent power.
Solvent Miscibility: The 434 is highly miscible with other common organic solvent. It can be mixed with:
- Water
- Alcohols
- Aldehydes
- Aromatic and Aliphatic Hydrocarbons
- Ethers
- Glycols
- Glycol Ethers
- Ketones
Available MSDS:
Tam ešte nikto nepísal; buď prvý!
